Photoluminescence Measurement set up (PL Set up)
| Name of the Equipment | Photoluminescence Measurement set up (PL Set up) |
| Category | litho/analytical |
| Operator | |
| System Owner | |
| Short Name | |
| Make/ Model | Princeton Instruments/ Acton SP2300 |
| Critical Tool | No |
| Serial Number | NA |
| FootPrint | 4*5 |
| InstallationDate | 06/15/2008 |
| Equipment Type | Material and structural characterization tools |
| Location | Micro2 Lab |
| AMC | Not Required |
| Local Dealer | NA NA |
| Actual Dealer | Advanced Photonics NA |
| Training & other policy documents | POLICY/157_POLICY.pdf |
| Recipe List | |
| Glimpse | GLIMPSE/157_GLIMPSE.pdf |
| Tool Facilities Requirements | Liquid Nitrogen, Nitrogen air, Chilled water |
| Access | Controlled |
| Lab Phone No | |
| Substrate allowed | GaAs |
| Substrate Dimension | Less than 10mm |
| Chemical allowed | Not allowed, Solid semiconductor samples with emission wavelength of 700-1400nm |
| Precursors/ Targets allowed *Based on stock availability | No target |
| Precursor/ Target loaded inside tool | |
| Target dimension | 1cm*1cm |
| Gases allowed | Not allowed |
| Contamination remarks | NA |